Fiat 500 push car - Product Specifications and Parameters; Components List; Assembly Diagram; Installation of rear axle and wheel

I. Product Specifications and Parameters
1.
This product is applicable for children with 2-6 years old and must be used under supervision of the adults!
2.
Product dimensions: 86.7x54.7x92cm
3. Product maximum load weight: 23 kg
4. Product operating ambient temperature: 0-40CC
5.
Steering wheel power supply: 2x1 .5V AA battery (excluded in this product)
II. Components List
1. Car Body
6. Wheel cover
4PCS
-;t
12. Ring
4PCS
7. Seat 13. Latch spring
4PCS
2. Windshield
..- 8. Seat backrest 14. screw 4x 1 5TAB(D=7.5)
3. Steering Wheel
9. Push handle 15. Steering wheel screw
(5x33PM)
4. Rear-view mirror
2PCS
10. Rear wheel axle
---------.
-
16. Steering wheel
locknut (51MM)
5. Wheel
11. Plastic tube
4PCS
2PCS
Ill. Assembly Diagram
Installation of rear axle and wheel
o
Insert rear axle shaft (part 10) in specified position of vehicle body.
@ Install rear-wheel rubber sleeve (part 11), vehicle wheel (part 5) andiron washer (part 12) in rear axle shaft
successively, and then clamp retaining spring (part 13) in groove of the axle, finally tightly clamp wheel cover
(part 6).
O
Put the wheel (part 5) and ring (part 12) into the front axle in sequence, clamp them into the groove position
of the axle with the latch spring (part 13) and fasten the wheel cover (part 6).