CLUTCH OVERHEATING -
SEE MANUAL
This message appears in the display to-
gether with an acoustic signal when the
clutch overheats.
In this situation, limit setting off and gear
changes or, if necessary, park (turning off
the engine) until optimum conditions are
restored.
Contact an Abarth Dealer-
ship if the message remains in
the display.
In order to safeguard the efficiency of the
clutch, do not use the accelerator to keep
the car stationary (e.g. when stopped on
an incline); if the clutch overheats it could
damage it; use the brake pedal instead
and only use the accelerator pedal when
you decide to set off.
20
PRESS BRAKE PEDAL
This message is shown in the display to-
gether with an acoustic signal during an at-
tempt at starting when the brake pedal is
not pressed.
REDUCE GEAR CHANGES
This message appears in the display to in-
dicate that the driver is using the gearbox
incorrectly.
Incorrect use (by the driver) could auto-
matically activate a procedure for protect-
ing the system.
MANUAL MODE
NOT AVAILABLE
This message is shown in the display when
it is not possible to select MANUAL
mode with the engine running.
Contact an Abarth Dealer-
ship if the message remains in
the display.
Contact an Abarth Dealer-
ship if the message remains in
the display.
AUTOMATIC MODE
NOT AVAILABLE
The message appears in the display when
it is not possible to select AUTO mode
with the engine running.
Contact an Abarth Dealer-
ship if the message remains in
the display.
603_95_XXX ABARTH 500C GB 1ed 10/03/14 10.31 Pagina 20
To Next Page
Loading...
