170
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONSINDEX
DASHBOARD
AND CONTROLS
IN AN
EMERGENCY
Please note:
❒ the jack weight is 3.5 kg
❒ the jack requires no adjustment
❒ the jack cannot be repaired and in the event of a fault it must be
replaced by another original one
❒ no tool other than its cranking device may be fitted on the jack.
To change a wheel proceed as follows:
❒ Stop the car is a position that is not dangerous for oncoming traffic
where you can change the wheel safely. The ground should be flat and
adequately firm. At night choose a lit area;
❒ Turn the engine off and pull up the handbrake;
❒ Engage first gear or reverse;
❒ Take out tools, jack and space-saver spare wheel;
❒ Tools are located in a compartment on the left side of the boot. To
have access, turn the clasp (A) anticlockwise and take off cover (B);
they are secured by a strap (C) that has to be released to remove
them;
❒ Label (D) on the internal side of the cover shows how to remove and
refit tools in the compartment;
❒ The space-saver spare wheel is located under the body at the back of
the car;
F0E0618m
F0E0122m
To Next Page
Loading...
