175
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX DASHBOARD
AND CONTROLS
IN AN
EMERGENCY
REFITTING THE STANDARD WHEEL
❒ Following the procedure described previously, raise the car and
remove the space-saver spare wheel;
❒ fit the standard wheel.
Make sure that the resting surface of the spare wheel is clean and there is
no dirt that could cause the bolts to loosen.
❒ Tighten the bolts with the wrench supplied;
❒ Lower the car and remove the jack;
❒ Tighten the bolts in the sequence shown before;
❒ Make sure the retaining ring (B) is inserted in the seats of the hub cap
so that the protruding section of the inflation valve is aligned with
symbol
C
marked on the inside of the hub cap;
❒ Press-fit the wheel cap on the rim, making sure symbol
C
on the inside
of the cap, corresponds with the inflation valve.
Incorrect fitting may cause the wheel cap to come off when the car is
travelling.
F0E0619m
F0E0247m
To Next Page
Loading...
