the changes already stored by the user (and
confirmed by pressing the SET button briefly)
will be saved.
From the standard screen, press the SET
button
briefly to start browsing.
Press the
or buttons to navigate within the
menu.
Note Only the reduced menu can be accessed while
the vehicle is moving for safety reasons ("Speed
Beep" setting). Stop the vehicle to access the full
menu.
Adjusting the vehicle interior lighting
This function is available with the dipped beam
headlights on to adjust brightness of the instrument
panel, buttons and radio display.
To adjust the light intensity, proceed as follows:
press the SET
button briefly to make
the display flash the previously set level;
press the or button to set the required
brightness level;
press the SET button briefly to go back to the
menu screen or hold the button down to go back
to the standard screen without saving.
Speed limit (Speed Beep)
This function makes it possible to set the vehicle
speed limit (km/h or mph). When this limit is
exceeded the driver is immediately alerted (see
“Warning lights and messages” section).
To set the desired speed limit, proceed as follows:
- press the SET
button briefly, the display will
show the wording (Speed Beep);
- press the
or button to select speed limit
activation (On) or deactivation (Off);
- if the function is on, press
or button to
select the desired speed limit and then press SET
to confirm.
Note Setting is possible between 30 and 200 km/h,
or 20 and 125 mph, according to the previously
set unit. See the "Setting the unit of measurement
(Measurement unit)" paragraph described below. The
setting will increase/decrease by 5 units each time
button
/ is pressed. Hold down the /
button to automatically increase/decrease the
setting rapidly. Complete the adjustment with single
presses of the button when you approach the desired
value.
- press the SET
button briefly to go back to the
menu screen or hold the button down to go back
to the standard screen without saving.
To cancel the setting, proceed as follows:
- press the SET
button briefly to make the
display flash (On);
- press button
, (Off) will flash on the display;
- press the SET
button briefly to go back to the
menu screen or hold the button down to go back
to the standard screen without saving.
19
KNOWING YOUR
VEHICLE
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
CARE
TECHNICAL DATA
INDEX
To Next Page
Loading...
