123
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
Group 1
For proper mounting proceed as follows:
❒
move the rear sliding seat fully back-
wards with the seat back at 4
th
position,
as shown in fig. 16;
❒
check whether the release lever B-
fig. 17 is at rest position (inward);
❒
find the presetting brackets A, then po-
sition the child restraint system with
the fastening devices C aligned with the
brackets;
❒
push the child restraint system until
hearing locking clicks;
❒
for seats positioned facing the running
direction, hook the upper belt D-
fig. 18 (in the upper seat pocket) to the
ring E in the boot;
❒
Check proper locking by moving the
child’s seat with force: the built-in safe-
ty mechanism actually inhibits improp-
er coupling with only one coupling
locked.
With this configuration, the child is se-
cured also by the car seat belts and by the
upper belts. To apply car seat belts to
child’s seat refer to the child’s seat hand-
book.
fig. 17
F0C0139m
fig. 18
F0C0428m
In case of rear sliding seat,
move the front seat forward
to a position from half its stroke forth.
WARNING
To Next Page
Loading...
