5
BASIC ACTIVATION
#2: Basic activation
1. Press and turn the button counter-clockwise to open the casing.
2. Remove the paper strip underneath the battery.
3. Press and turn the button clockwise to close the casing.
4. Place the device within the direct range of your Z-Wave controller.
5. Set the main controller in (security/non-security) add mode (see
the controller’s manual).
6. Click the button 6 times at least.
7. Wait for the device to be added into the system, successful adding
will be conrmed by the controller.
8. Install the device in desired location using the attached
self-adhesive pad.
9. Click the button 4 times to wake it up.
To Next Page
Loading...
