10
ADVANCED PARAMETERS
NOTE
Setting parameters
11, 13, 15, 21, 23 and
25 to appropriate val-
ue will result in:
1-99 - forcing level of
associated devices
255 - setting associat-
ed devices to the last
remembered state or
turning them on
i
3. Associations in Z-Wave network Security Mode
This parameter denes how commands are sent in specied associa-
tion groups: as secure or non-secure. Parameter is active only in Z-Wave
network Security Mode. It does not apply to 1st „Lifeline” group.
Available settings: 1 - 2nd group sent as secure
2 - 3rd group sent as secure
4 - 4th group sent as secure
Default setting: 7 (all) Parameter size: 1 [byte]
10. Key Pressed 1 time – command sent to 2nd association group
This parameter denes commands sent to devices associated in 2nd
association group after a single click.
Available settings: 0 - no action
1 - SWITCH ON
2 - SWITCH OFF
3 - SWITCH ON/OFF – alternately
Default setting: 3 Parameter size: 1 [byte]
11. Key Pressed 1 time – value of SWITCH ON command sent to
2nd association group
This parameter denes value of SWITCH ON command sent to devices
in 2nd association group after a single click.
Available settings: 1-255 - sent value
Default setting: 255 Parameter size: 2 [bytes]
12. Key Pressed 2 times – command sent to 2nd association group
This parameter denes commands sent to devices associated in 2nd
association group after a double click.
Available settings: 0 - no action
1 - SWITCH ON
2 - SWITCH OFF
3 - SWITCH ON/OFF – alternately
Default setting: 1 Parameter size: 1 [byte]
13. Key Pressed 2 times – value of SWITCH ON command sent to
2nd association group
This parameter denes value of SWITCH ON command sent to devices
in 2nd association group after a double click.
Available settings: 1-255 - sent value
Default setting: 99 Parameter size: 2 [bytes]
NOTE
Values of parameter
3 may be combined,
e.g. 1+2=3 means that
2nd & 3rd group are
sent as secure.
i
To Next Page
Loading...
Need help?
General
