FIBARO CO SENSOR User Manual

9
Reset
Reset procedure allows to restore the accessory back to factory settings.
1) Press and hold the button.
2) Release the button when LED indicator glows white.
3) Click the button when LED indicator glows yellow.
4) After few seconds the device will be reset (conrmed by red LED indicator).
Self-test
Caution! The alarm is very loud! Only the rst alarm sequence is quieter.
1) Press and hold the button.
2) The LED indicator will glow white and you will hear a short beep - keep holding the button.
3) Release the button when you hear the rst alarm sequence.
4) Move away from the device to protect your hearing.
Battery replacement (page 4)
1) Remove the device from the cover by turning it counter-clockwise.
2) Pull the paper strip to take out the battery.
3) Press and hold the button for at least one second.
4) Insert a new CR123A battery observing the polarities shown inside.
5) Attach the device to its cover by turning it clockwise and perform the test.
Legal information
Fibaro and Fibar Group are registered trademarks of Fibar Group S.A. The Bluetooth word mark is registered trademark
of Bluetooth SIG, Inc. Apple and HomeKit are registered trademarks of Apple Inc.
Use of the Works with Apple HomeKit logo means that an electronic accessory has been designed to connect specically
to iPod touch, iPhone, or iPad, respectively, and has been certied by the developer to meet Apple performance stand-
ards. Apple is not responsible for the operation of this device or its compliance with safety and regulatory standards.
Hereby, Fibar Group S.A. declares that FIBARO CO Sensor is in compliance with the essential requirements and other
relevant provisions of Directive 2014/53/EU.
Device should not be disposed with other household wastes. It shall be handed over to the applicable collection point
for the recycling of waste electrical and electronic equipment.
ENGLISH
Technical data
Battery type: 3V, CR123A (included)
Battery life: 3 years on default settings
(tested with Panasonic
Industrial Lithium)
Lifespan under
typical conditions:
8 years
Operating
temperature:
0-50°C (32-122°F)
Operating humidity: 10-95%RH without
condensation
Alarm response
times on default
settings:
50ppm 60-90min
100ppm 10-40min
300ppm <1.5min
Measuring
accuracy:
±10ppm / ±5%
Radio protocol: Bluetooth® low energy
Radio frequency: 2.4 GHz
Dimensions (d x h): 65 x 28 mm
Conformity with EU
requirements:
RED 2014/53/EU
RoHS 2011/65/EU
EN 50291-1:2010

FIBARO CO SENSOR Specifications

General

Brand	FIBARO
Model	CO SENSOR
Category	Gas Detectors
Language	English