FIBARO Door/Window Sensor - English

5
FIBARO Door/Window Sensor is a HomeKit-ena-
bled Hall eect sensor using Bluetooth
®
low energy
wireless technology.
Along with detecting opening and closing, the
accessory measures the ambient temperature.
Opening is detected by separating the sensor’s
body and the magnet.
Tampering is detected whenever the accessory is
detached from the surface or casing is opened.
ENGLISH
TIP: Check corresponding chapters of Quick Start
Guide for pictures.
Package contents (page 3):
• Device,
• Magnet,
• Manuals and warranty terms.
Download FIBARO app from the App Store (page 4).
First launch (page 5):
1) Take o the cover (Fig. 1).
2) Remove the battery blocker and check if the bat-
tery is placed correctly (Fig. 2).
3) Close the cover (Fig. 3).
4) Open the FIBARO app and tap icon (Fig. 4).
5) Application will guide you through the pairing
process.
6) Peel o the protective layer from the sensor and
magnet (Fig. 5).
7) Stick the sensor onto the frame and magnet onto
the moving part of the door/window (no further
than 5mm from the sensor) (Fig. 6).
Setup Code:
You will nd the Setup Code on the back of the
Quick Start Guide. Remember to keep it in a safe
place. You may need it in case of re-pairing.
Reset (page 7):
1) Take o the cover.
2) Press the button 3 times then press and hold the
button (Fig. 7).
3) When the LED glows, release the button.
4) Click the button again immediately to conrm.
For more information about
FIBARO Door/Window Sensor,
like video guides, parameters,
technical manuals, and declara-
tions visit our website:
manuals.baro.com/en/hk-door-window-sensor
Specications:
Power supply: ER14250 (½AA) 3.6V battery
Radio protocol: Bluetooth
®
low energy
Radio frequency: 2.4 GHz
Max. transmit power: +9,5 dBm
Operating temperature: 0-40°C (32-104°F)
Dimensions (D x W x H): 71 x 18 x 18 mm
(2.8" x 0.7" x 0.7")
EU directives compliance: R&TTE 1999/5/EC
RoHS 2011/65/EU
RoHS 2015/863
Warnings:
Failure to observe recommendations included in the
manual may cause risk to health or malfunction of
the device. The manufacturer, Fibar Group S.A. will
not be held responsible for any loss or damage re-
sulting from not following instructions of the man-
uals.
This product is not a toy. Keep away from children
and animals!
Risk of explosion if battery is replaced by an incor-
rect type. Dispose of used batteries according to the
instructions.
The device is designed to be used with Apple
HomeKit and is compliant with IEC/UL/CSA 60950-1.
In case of the integration with another system, e.g.
alarm system, it is required to verify the compliance
with additional standards.