FIBARO Motion Sensor - Mounting and Resetting; Sensor Mounting; Factory Reset Procedure

7
First launch
Resetting the Motion Sensor to factory defaults:
1. Open the cover
2. Press and hold the button
3. When the LED glows yellow, release the button
4. Click the button again to confirm
Button
Install the sensor’s holder in desired
location. Motion Sensor can be
mounted using screw or the sticker
Step 7
Insert the Motion Sensor
in its holder
Step 8
After resetting the accessory
will blink red — it is ready
to be paired again.
!
Fig. 6 Fig. 7
Fig. 8