FibroPool FH235-I - Page 5

II. Safety Informa"on
NOTE: Opera"ng heat pumps at near-freezing temperatures risks damage to the heat
exchanger. Heat pumps must be empty of water at freezing temperatures. See
winteriza"on guidelines for more details.
● Verify the ground connecon before operaon. Improper grounding increases the risk electric
shock and death.
Grounding protects both swimmers and technicians from electric shock. It is absolutely necessary
to properly ground the unit.
● Heat pumps should be installed outdoors when possible. If necessary, indoor installaons must
have adequate venlaon and clearance.
● Keep children away from the heat pump. The lock funcon can be used to prevent improper
operaon.
● Keep #ngers and other objects away from the fan. Fan blades are extremely sharp and can cut or
damage objects put inside.
● If you noce any unusual sounds, burning smell, electrical shorts, etc., please immediately
disconnect the heat pump and contact Fibropool support.
● Do not install the unit near any combusble objects or materials.
● Install the heat pump such that the base rests on a solid, level foundaon.
● When cleaning the unit, the heat pump should be o? and disconnected from any power source.
Required Opera"ng Condi"ons:
1. Power supply: 208-230V 50/60Hz.
2. Air temperature: 35°F-105°F
3. Water temperature range:
45°F-104°F in Heang Mode
45°F-82°F in Cooling Mode