• Once all screws are in position and hand tight, go ahead and tighten them using a wrench.
• Insert upper leg bolts and tighten
• Insert Leg Anchors and tighten.
2 Front and Left leg anchor (3) Middle Right anchor (1) Ladder anchor(2)
• Note: 3 anchors are same, 2 for the front, 1 for the left side of the slide. 2 angled anchors
are for ladder; 1 wavy anchor is for the right side of the slide(middle leg, right side,
looking from the ladder to the tip of the slide.
• If the deck is not level, slide the feet up and down and drill at the appropriate location
• Insert water sprayer, silicone washer on top of slide; and hand tighten
To Next Page
Loading...