CHANGING THE CODE ON THE ELECTRONIC COMBINATION
- Open the safe by following the procedure above, and keep the door
open.
- Press “Enter” and enter your opening code (“0.0.0.0.0.0)” is the
factory code) then Validate by pressing “Enter” again.
- Enter “0” and press the Enter key again to start the code modification
procedure - the yellow indicator should light up.
- Enter the new opening code (6, 7, or 8 digits) and validate by pressing
Enter.
- Enter your new opening code again and validate by pressing Enter.
- The green indicator should blink 3 times to indicate that the new code
has been taken into account, then the green and yellow indicators switch
off.
- Keeping the safe door open, open and close the electronic combination
several times to check that you new code is working properly.
IMPORTANT
: Before using the advanced functions of the electronic
combination, please refer to the instructions for the electronic
combination Nectra.
FR
To Next Page
Loading...