Field Controls SWG-4HD Quick Start Guide

page 3
INSTALLATION
1. Align the holes in the circular cover plate with the holes in the motor mount bracket on the motor
assembly. (See Figure 3)
2. Slide the motor assembly onto the protruding threaded studs on the power venter body with the exhaust
chute pointing downward, and replace the nuts securely to the threaded studs. (See Figure 3)
3. Use the top knockout on the electrical box and reattach the  exible conduit and wires to the motor using
the conduit connector and wire nuts. Secure the cover on the electrical box.
4. Seal around the edge of the motor mount bracket with high temperature silicone sealant. Install the motor
cover with the side louvers pointing downward. (See Figure 1)
Figure 3
P/N 46252300 Rev I 12/21

Field Controls SWG-4HD Specifications

General

Brand	Field Controls
Model	SWG-4HD
Category	Automobile Parts
Language	English