Page of 2
TRACTOR DRAWBAR STABILIZER USE AND CARE
1. Lock the top hole on the Stabilizer (#1) to your tractor center link by pin or bolt (not included).
2. The Stabilizer (#1) is for Category 0 tractor and you will need to add the Sleeve (#2) if you want
to apply on your Category 1 tractor.
3. Use Bolts (#3), Nuts (#4) and Washers (#5) to mount the bottom end of the Stabilizer (#1) to the
center of your drawbar, adjust the lift arm and make sure the Stabilizer is in vertical position and
perpendicular to the drawbar before you tighten the bolt and nut.
4. The drawbar stabilizer is ready to use.
5. You can add a 2”x 2” ball mount or other equipment with 2”x 2” shank. Make sure the pin is
locked (not included) and does not exceed 200 lbs. tongue weight capacity.
WARNING
1. Always check for damages or worn out parts before each use.
2. Do NOT exceed 200 lbs. tongue weight maximum capacity.
3. Do not modify the Tractor Drawbar Stabilizer in any way.
DIAGRAM & PARTS LIST
For replacement parts and/or technical
questions, please call 218-943-6290.
WARRANTY: One-year Limited Parts
Warranty
PO Box 155
Miltona, MN 56354
TEL: 218-943-6290
www.bacindustries.com
Made in China
To Previous Page
Loading...