EN
ELECTRIC HANDHELD PLANER OPERATING INSTRUCTIONS
13
3. %&4$3*15*0/ (Figs. 1/2/3)
1. Setting knob for the chip depth
2. Dust bag
3. Safety lock-off
4. ON/OFF switch
5. Rear base plate
6. Belt cover
7. Chip ejector
8. Front base plate
10. Power cable
11. Thumb screw for step depth scale
12. Step depth scale
13. Parallel stop
4. PROPER USE
The hand-held electric planer is designed for planing, rabating and chamfering pieces of wood.
The machine is to be used only for its prescribedpurpose. Any other use is deemed to be a case of misuse.
The user / operator and not the manufacturer will be liable for any damage or injuries of any kind caused as a
result of this.
Please note that our equipment has not been designed for use in commercial, trade or industrial applications.
Our warranty will be voided if the machine is used in commercial, trade or industrialbusinesses or for equivalent
purposes.
5. BEFORE STARTING THE EQUIPMENT
Before you connect the equipment to the mains supply make sure that the data on the rating plateare identical
to the mains data.
Always pull the power plug before making adjustments to the equipment.
5.1 Adjusting the chip depth (Fig. 4/Item 1)
You can adjust the chip depth in steps of 0.1 mm from 0 to 2 mm by turning the setting knob for the chip depth (1).
Turn the setting knob for the chip depth (1) in a clockwise direction to set a greater chip depth:
Greater chip depth
Layout | Propeer Use | Before starting the equipment
To Next Page
Loading...