EN
CORDLESS CIRCULAR SAW USER’S MANUAL
Preparing the circular saw
11
Dust Extractor
Always use the sawdust extractor facility. You can use a dust extractor, whereby the traditional flexible hose can
be inserted into the extractor connection (1 ).
MAINTENANCE:
- Adjusting for accuracy of 90° cut.
Never use excessive farce when sawing. Too much pressure reduces the speed of the machine, and the
required power drops rapidly. This results in overloading which may damage the motor. lf the machine
becomes too hot, allow it to run without a load for two minutes.
Clean the machine with a clean cloth and a brush. Do not use any solvents. Ensure that the ventilation slits
are not blocked!
- Replacing carbon brushes
Remove and check the carbon brushes regularly. Replace when they wear down to the limit mark. Keep the
carbon brushes clean and free to slip in the holders. Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps, take aut the worn carbon brushes, insert the new ones
and secure the brush holder caps.
- To extend the working life of your tool, you must have the tool serviced by an authorized SCHEPPACH
servicing agent.
- For more information please contact info@newcopowertools.co.za
Warning! Be sure to switch power off and disconnect the plug.
ENVIRONMENTAL PROTECTION
Electrical products should not be disposed of with household waste. Please recycle where facilities exist.
Check with your local authority or retailer for recycling advice.
To Next Page
Loading...