EN 14
FDMB 200171-E
Operating instructions
USEFUL HINTS AND TIPS
1. Your multifunctional power tool will become warm after prolonged
use and so must be switched off and allowed to cool down.
2. To ensure smooth running, the spindle should be oiled periodically.
3. Do not apply too much radial pressure to the accessory bits while
polishing, cleaning, sanding, or grinding. By doing this you will put a strain on
the spindle and adversely affect the precision of the tool.
4. Always work with a sensitive touch so as not to impede the
efficiency of your multitool.
5. When drilling metal, always mark the drilling point with a center
punch first so that your rotary tool does not slip.
6. Always ensure that your have maximum contact between the
accessory shaft and the collet chuck.
7. Vary the speed on the tool for the work in hand, eg. low speed for
polishing, cleaning, and high speed for engraving.
PLACINT ACCESSORIES INTO THE TOOL
Always switch the tool off first. Hold the locking button at the front of the tool
down and undo the collet chuck (anti-clockwise). Insert the collet that
matches the shaft size of the accessory to be used. Place the collet nut over
the collet and then insert the accessory shaft into the collet chuck ensuring
maximum shaft contact. Then tighten up the collet nut. (DO NOT USE PLIERS).
To Next Page
Loading...