EN
MINI GRINDER
OPERATING INSTRUCTIONS
13
Operating instructions
4.
OPERATING INSTRUCTIONS
MULTIFUNCTION POWER TOOL USE
This rotary tool can be used for drilling, grinding, sanding, and polishing, as well as
engraving, cutting, and removing rust in tight spaces or inaccessible places. The
tool can be used on most metals, glass, wood, and ceramics. For best
performance and results keep the speed as even as possible without exercising
too much pressure. As a guideline, use the tool at low speed for all large
accessories, such as polishing fro example, and at high speed for smaller
accessories such as those used for engraving. For grinding and engraving, hold
the tools as if it were a pen.
MULTIFUNCTION POWER TOOL START-UP
Never start up or stop the tool is the accessory is in contact with the piece to be
worked on. Hold it firmly and press the ON/OFF switch. The tool will run
continuously until the switch is turned to OFF position. The speed can be adjusted
while the tool is running.
SPEED ADJUSTMENT
The multifunction power tool is equipped with the speed control. Do not change
the speed while the tool is working. The speed switch is located on the rear of the
too. Turn it to increase or reduce speed. Use the tool at low speed for polishing
and similar operations, but use higher speed for drilling or cutting action.
IMPORTANT GENERAL SAFETY TIPS!
1. The tool should be unplugged when changing accessories.
2. If you stall the tool, switch it off immediately.
3. Periodically check the tightness of your collet chuck, especially during
prolonged use of the same accessory.
4. After use, always disconnect your power tool.
5. Do not undertake repair of the power tool yourself.
6. Do not leave your tool unattended while switched on.
7. Do not use or store your tool in damp or wet conditions.
To Next Page
Loading...