EN
ELECTRICAL JIG SAW USER'S MANUAL
13
Use
Let the blade work through the item, continuing to tip the saw downwards until the sole is fl ush to the item
and the blade is perpendicular to it. If necessary, drill a hole of suitable diameter in the item for use as
starting point.
Sawing wood
Check that the item does not contain nails or other metal objects. Always wear a mask.
Sawing metal
We recommend lubricating the material and saw blade with cutting oil to protect the tool and avoid overheating.
Support the item with wooden blocks on either side.
Sawing plastic
Make a test cut fi rst to check if the material can tolerate the heat generated by sawing.
Important!
Check all screws on the saw regularly, particularly those that hold the blade. Tighten if required. Check regularly
that the carbon brushes are in a good condition. If the carbon brushes are worn, they should be replaced.
Lubrication (Fig. 2)
Regularly apply a drop of oil to lubricate the guide roller (7).
Cleaning and maintenance
Caution: always be sure that the tool is switched off and unplugged before attempting
to perform inspection for maintenance.
In order to maintain product reliability and safety, repairs, replacement, any other maintenance or adjustment,
and carbon brush inspection and replacement should be performed by specialized work shop.
Wipe the saw using a well-wrung cloth after use, and always keep the surface and ventilation holes free of dirt.
Keep the soleplate free of dirt to avoid the saw cutting incorrectly.
Never use corrosive or abrasive cleaning agents, as they may attack the plastic parts of
the saw.
When the carbon brushes wear out the tool will spark and/or stop. The brushes are a wearing component of the
tool and should be replaced prior to the carbon wearing out fully. Always replace both brushes at the same time.
CAUTION: the carbon brushes must be replaced by a pair similar carbon brush available through the after-
sales service organization or qualifi ed professional person.
CAUTION: Always disconnect the machine from the power supply before removing any electrical covers.
CAUTION: Do not use cleaning agents to clean the plastic parts of the tool. A mild detergent on a damp
cloth is recommended. Water must never come into contact with the tool.
To Next Page
Loading...
