EN 14
FDP 200451-E
Machine care | Warranty | Technical specifications
8. MACHINE CARE
Overload
Never use excessive force when cutting. Too much pressure reduces the speed of the machine, and the required
power is greatly reduced. This may result in overload which can damage the motor of the machine. When the
machine becomes too hot, allow it to run for two minutes at no load and then interrupt working for a short time.
Clean the machine with a clean cloth and a brush. Ensure that the ventilation slots are not blocked.
9. WARRANTY
The Warranty Card shall be valid only when submitted together with the purchase receipt.
Keep the both documents in a safe place. To lodge a warranty complaint, turn to your dealer or a service centre.
The warranty shall apply to all product defects and faults that occurred during the warranty period and were
demonstrably attributable to material or manufacturing defects. In such cases the product shall be repaired
and/or adjusted. The warranty shall not apply to standard wear of the product, as well as to faults attributable to
overloading, using of inappropriate accessories or improper operation of the product.
10. TECHNICAL SPECIFICATIONS
Voltage 220V 50 Hz
Power rating 450W
No-load speed 0–3000/min
Max. Cutting depth in
Wood 55 mm
Steel 6 mm
Mitre angle 0–45°
Instructions Manual - language version only.
To Next Page
Loading...
