EN
MINI PLUNGE SAW FDPP 200705E
13
Operation
6. OPERATION
Switch On/Off
Note: Before turning on / off the switch, check the saw blade for proper installation and smooth
operation, bolt tightening condition.
To start the machine, press the Lock-off button and press the trigger.
To stop the machine, release the trigger, and then the machine stops.
Depth adjustment
Before cutting, move the depth guide lever on the depth guide bracket to the desired position and fi x it.
Protection System
This system automatically cuts off power to the motor extend tool and battery life.
The tool will automatically stop during operation if the tool or battery is placed under one of the following
conditions:
Overload Protection
When the tool is operated in a manner that causes it to draw an abnormally high current, the tool automatically
stops without any indications. In this situation, turn the tool off and stop the application that caused the tool to
become overloaded. Then turn the tool on to restart.
Overheat Protection
When the temperature of the machine is overheated, the machine stops automatically. In this situation, let the
machine cool before turning on again.
To Next Page
Loading...
