EN 18
FDU 2004-E
Safety measures
5. SAFETY MEASURES
Vacuuming water
When vacuuming water attach the special fl oor nozzle with rubber squeegees (see pic. 3)
and take the dust bag out of the container. Under no circumstances should you use a carpet
nozzle with a metal underside for wet vacuuming - risk of corrosion!
If while vacuuming water, the container becomes fully fi lled, a safety fl oat will stop the
suction and the noise level of the motor will increase dramatically. Further vacuuming is only
possible after the container has been emptied.
CAUTION: If while vacuuming water the vacuum cleaner tips over, it is necessary to have
the vacuum cleaner motor inspected by a service before further use.
CAUTION: Never use this vacuum cleaner as a full substitution for a pump, i.e. pumping
water from tanks, baths, aquariums, etc. The seal on the hose could be damage by the high
pressure.
CAUTION: After fi nishing vacuuming of water it is necessary to allow the vacuum cleaner
to run for another 30 seconds, so that the remaining water is sucked out of the hose and
tube.
Turning your vacuum cleaner on and off
To switch your machine on or off, press the I/O button on the vacuum cleaner body.
Adjusting the suction strength
The suction strength may be adjusted by turning the dial on the product's body (small range)
or by the moveable flap on the hose handle.
To Next Page
Loading...
