FZN 2305-E
14EN Technical data
13. TECHNICAL DATA
Voltage/Frequency 230
~
240 V/50 Hz
Idling speed
Input power
Blade length
Working length
Maximum cutting diameter
Weight
Instructions Manual - language version only.
15
USER‘S MANUALELECTRIC HEDGE TRIMMER
ENDeclaration of conformity
1. DECLARATION OF CONFORMITY
14. WHAT TO DO "WHEN..."
The following table describes the inspections and procedures you may perform if your tool is not
working properly. If these instructions do not help in identifying or remedying the problem, please
contact an authorised service centre.
WARNING!: Turn off the tool and disconnect the power plug from the socket before
troubleshooting.
When... Possible cause Remedy
The hedge trimmer
is not working
– No power supply
– Faulty power socket
– Damaged extension cord
– Check the power supply
– Try a different power socket, replace it
– Check the power cord and if necessary replace it
(Contact an authorised service centre)
The hedge trimmer
is not work
intermittently
– Damaged extension cord
– Internal electrical wiring fault
– Damaged power switch
– Check the power cord and if necessary replace it
– Immediately contact an authorised service centre
– Immediately contact an authorised service centre
The motor is running
but the blades are not
moving
– Internal fault – Immediately contact an authorised service centre
The trimmer's cutting
blades are hot
– Blades are blunt
– Trimmer's cutting blades are deformed
– Excessive friction caused by an insufficient
amount of lubricant
– Have the blades sharpened
– Have the blades repaired
– Use a lubricant in a spray
Declared noise level 105db(A)
Maximum vibration level 2.285m/s2 K=1.5m/s2
1750 ot./min
550 W
500 mm
460 mm
16 mm
2,50 kg
To Next Page
Loading...
