Before Use
Unpacking and assembling the device:
Carefully take the device out of the box, remove all transport packaging and check
that no damage has been caused during transport and that the delivery is complete:
1 x basket insert
1 x curved insert
Place the ultrasonic cleaner on a rm, even surface so that it cannot tip or tilt.
The surface should be easy to clean, well lit and easily accessible. Do not place the
device on or next to any surface that could get hot, e.g. on a cooker hob or next to
a gas cooker.
Use
Open the Iid of the device. Place the item to be cleaned in the middle of the basket
insert supplied to achieve the best cleaning result.
Cleaning watch straps:
You can use the curved insert supplied for metal watch straps.
Since it rises above the MAX marking, it allows you to place watches in the device.
To avoid having to remove the watch housing lrom the strap, ax the watch in such
a way that the housing is elevated above the cleaning liquid.
WARNING: If the watch mechanism is immersed in the liquid it may be damaged
by the ultrasonic waves during the cleaning process.
1. Then ll the tank with water. If the tank overows, wipe the outside of the
device dry immediately. The liquid must cover the item to be cleaned, but should
never come above the maximum lling Ievel mark.
CAUTION: Never operate the device without a sucient amount
of water in the tank to prevent damaging the electronics.
2. Close the Iid and plug the power plug into a suitable safety socket.
Note: This device requires a mains voltage of 230 V AC! (See nameplate at
bottom of device.) The indicator ① for the mains power supply on the underside
of the Iid lights up blue.
14
To Next Page
Loading...