7 . BEFORE TO CALL FOR SERVICE ASSISTANCE
Before to call the technical assistance, it is suitable to check the followings failures more common and ope-
rate in conformity.
PROBLEM CAUSE SOLUTION
The machine does not work. Lack of power Check the plug
Disconnected plug connect the plug
Any of above points Contact the assistance service
Low working temperature Heating element bad working Contact the builder
Uncalibrated thermostat See the instruction for the calibration
Not or bad working thermostat Contact the builder
Room temperature under 18°C Place the incubator into a warm room
Thermometer with colored liquid Impacts, accidental drop Try to expose the thermometer for few
interrupted minutes to low temperatures (freezer)
then in cold water otherwise substitute it
Automatic egg-turner Lack of power Check the plug
device does not work
Plug disconnected Put the plug into the socket
Egg-turner motor broken Contact the builder
Insufficient ventilation Fan Motor does not work Contact the builder
It is severely forbidden any attempt of reparation of the machine, which is not between those suitable in the
aboveshow table, contact always technical assistance at the factory to the tel. 0039 031 / 97 66 72 ISND
fax. 031 / 89 91 63 – www.fiem.it - e-mails: fiem@fiem.it o incubators@fiem.it.
16
DECLARATION OF CONFORMITY
To senses of the attachment I, D.Lgs. 17/2010/CE
THE MANUFACTURER
F.I.E.M. S.r.l.
Via G. Galilei, 3 - 22070 Guanzate (Como) - Italy
D E C L A R E S T H A T
THE MACHINE
Incubator
MODEL
SMART
MATRICULATION
IS MANUFACTURED AND SOLD IN CONFORMITY TO THE ESSENTIAL
REQUIREMENTS OF HEALTH AND SAFETY D.M. 17 of 27 January 2010
Attachement I (implementation of the Machinery Directive 2006/42/EC)
The metallic plate apposited on the machine is an integral part of the same;
on the plate are reported all the datailed informations in the machine directory.
THE FOLLOWING ARMONIZED RELUS HAVE BEEN UTILIZED FOR THE CORRECT IMPLEMENTATION
OF THE ESSENTIAL REQUIREMENTS OF HEALTH AND SAFETY OF THE ATTACHED I
EN 55014-1:2006 + A1:2009 + A2:2011 EN 55014-2: 2015
EN 61000-3-3:2014 EN 61000-3-3:2013
Guanzate
The Declarator
To Next Page
Loading...
