QUICK START GUIDE
Part Number: 450319622003
Electronics For Imaging, Inc.
This
Quick Start Guide
provides system requirements and an overview of how to set up
the Fiery S300 31C-M Color Server
™
so you can begin printing. The guide describes
the initial tasks you must perform and points you to sections in the user
documentation where the procedures are described in detail. A full set of user
documentation is provided on the User Documentation CD. A brief description of
the user manuals and how to print them follows.
N
OTE
:
The term “Fiery S300” is used in this document to refer to the Fiery S300
31C-M Color Server. The term “Windows 9x” is used in this document to refer to
Windows 98. The term “Windows” is used in this manual to refer to Windows 98,
Windows Me, Windows NT 4.0, Windows 2000, and Windows XP, wherever
appropriate.
Media pack
Your Fiery S300 media pack should contain the following:
•User Software CD
•User Documentation CD
•Printed
Quick Start Guide
•Printed
Release Notes
•Kodak Gray Scale
About the documentation
Along with the printed
Release Notes
included in the media pack, documentation
is provided in electronic form on the User Documentation CD. The documents are
provided as Acrobat PDF (Portable Document Format) files, which are linked and
cross-referenced. A description of the documentation follows:
• The
Quick Start Guide
summarizes the steps for configuring the Fiery S300 and
setting up printing. It also describes how to access the online documentation.
• The
User Software Installation Guide
describes how to install software from the User
Software CD to enable users to print to the Fiery S300, and also describes setting up
printing connections to the Fiery S300.
To Next Page
General