Need help?Do you have a question about the filtreau UVC and is the answer not in the manual?
General| Brand | filtreau |
|---|---|
| Model | UVC |
| Category | Water Filtration Systems |
| Language | English |
Explains how the UV-C module ensures clear water by killing microorganisms.
Key safety and installation guidelines for proper and safe use of the device.
Connect to legal electrical installations with GFCI and earthed sockets. Consult an electrician if unsure.
Position electronics box and plug at least 2m from the tank, keeping them dry and preventing water tracking.
Never submerge the UV-C device in any liquid.
The device is designed to withstand a maximum water pressure of 3 bar.
The UV-C module is suitable for use with both fresh and salt water.
Operates between 0-40°C. Disconnect from water outside this range.
Inspect device, cord, and plug for damage before use. Do not use if damaged.
Ensure sufficient water flow through the device before connecting and operating.
Never look directly at the UV-C lamp to avoid harm to eyes or skin.
Disconnect from mains during maintenance. Lamp may remain hot for 10 minutes after disconnection.
Step-by-step instructions for installing the UV-C module.
Ensure the electronics box is visible for lamp change indicator and maintenance access.
Remove the lock nut (C) from the adapter (D).
Carefully unpack the UV-C lamp (B) and slide it into the quartz sleeve (E).
Insert lamp (B) into holder (F), slide into sleeve (E), ensuring O-rings (G1&G2) are seated.
Hand-tighten the lock nut (C) onto the adapter (D).
Instructions for mounting the device at the desired location.
Remove the fastening nut (H) from the adapter (D).
Position the device and tighten fastening nut (H) ensuring O-ring (I) is properly seated.
Check assembly for leaks, ensure water flow, and plug in; lights on electronics box will indicate status.
The device can be turned off by simply pulling the plug out of the socket.
Details on periodic maintenance and disassembly for cleaning or part replacement.
The device requires maintenance at least once per half year.
Instructions for replacing the UV-C lamp and resetting the device's operational timer.
Unplug the device from the mains and close the pipes before maintenance.
Ensure water is drained, then loosen lock nut (C) to disconnect lamp (B) from holder (F).
Carefully raise and clean the quartz sleeve (E) with an appropriate cleaner, rinsing thoroughly.
Place quartz sleeve (E) back, insert lamp (B) and holder (F), then tighten lock nut (C).
Press and hold button (J) on the electronics box (A) for 5 seconds to reset after lamp replacement.
Lists available Filtreau UV-C Module models with their part numbers.
Provides part numbers for electrical parts, quartz sleeve, adapter, and lamp.
Outlines the terms and conditions of the product warranty.
Supplier guarantees module for 24 months against defects; lamp and housing excluded.
Warranty void if repairs by third parties, cabling altered, or due to incorrect installation/use.
Warranty is valid only with a dated proof of purchase stamped by the supplier.
Supplier not responsible for damage caused by improper use or failure of apparatus.
Claims for transport damage must be reported to the dealer in writing within 24 hours.
Instructions for proper disposal and recycling of the product at its end of life.
Product must be collected separately from other rubbish for electric and electrical devices.
Return used product to seller when buying a new unit (1:1 ratio) or use collection centre.
To Next Page
