1. (Fig.13) To operate the Flexy insert the Opening rod I in the opening mechanism XX
2. To tilt the canopy follow these steps:
(Fig.14A - 14) Loosen the hand wheel S on both sides. The teeth of the casting must be fully separated allow free
movement of the top.. Re-tighten both handwheels S, making sure that the the teeth of both castings are fully engaged.
1. Close the sliding canopy A completely.
2. Put the protect cover and it with the .
CAUTION: always close the TENDASOL FLEXY in presence of strong winds or
thunder storms, as well as heavy rain (danger of waterpockets on the cover) whenever it is not under .
1. To apply lateral valances, rib .
2.
3. The frontal valances are fixed to the ribs by buttons .
1. Remove screws from both sides of the ribs.
Push the end of the panel outward removing it completely from the ribs.
2. To re-install the panel insert into the ribs. Take the panel with both hands and slide
it .
3. Insert the screw .
The can be cleaned by hand with a smooth cloth, lukewarm water (about 30°C 85°F) and a common detergent for delicate
fabrics. After extensive rinsing the material has to be dried. To extend the life span of the fabric, it is advisable not to perform
this operation in the bright sun.
For washing in industrial washing machines, take the off the structure have washed with a mild detergent, delicate
program, extensive rinsing and water temperature not exceeding 40°C ( 110°F). Have air (do not tumble dry!) and
do not iron.
To extend the life span of the product, it is advisable to disassemble and store the awning away in a dry place at the end of the
season. Before sto ing your FLEXY away, clean the structure with a damp cloth and dry it. For the cleaning of the
cover see the preceeding paragraph.
CAUTION: Check the integrity of all components. Should any part be damaged contact the dealer where it was
purchased and order the required spare parts.
Touch up any possibly chipped paint. Lightly lubricate all moving parts with silicon spray.
Important
To Next Page
Loading...