Note：
1. Please ensure the drone and the RC stay within 0.5m while pairing.
2. Ensure the battery level of drone and RC are more than 30%.
Remote Controller Pairing
When a new remote controller or drone is replaced, please pair the remote controller
and the drone again as shown below：
Turn on the drone and remote controller.
Wait for 20 seconds, then long press the power button of controller until hearing the
beep sound, and the light will be flashing.
Long press the power button of the drone till the tail light off.
The code pairing succeeds when the power button on the RC turns white and the
tail light on the drone keeps on.
Long press the power button. Long press the power button.
41
To Next Page
Loading...
Need help?
General
