FINAL SOUND 600i/1000i Loudspeaker Manual vs. 1.4 -US- c FS 2007RJ 6
.
4. Final Sound Model F600i/1000i floor standing loudspeakers
How to unpack the Final Sound F600i/1000i stereo system
The Final Sound Model F600i/1000i stereo system consists of three separate packaging units. The
Model F600i/1000i flat-panel loudspeakers, the floor plates and the optional Final Sound subwoofer
are packed separately.
(the 600i/1000i panels for the rear channels in home theatre applications are basically the same
panels as the front loudspeakers. All unpackaging and assembling instructions for the rear panels are
identical to those for the stereo front panels)
The Model F600i/1000i Stereo flat-panel loudspeaker packaging contains:
- 2 Model F600i/1000i flat-panel loudspeakers (left and right)
- 2 power supplies 12VDC
- 2 footplate assemblies (in a separate box)
- assembly materials including screws to fix the flat-panels to the footplates
- 1 manual
Each individual component is packed in its own carton. The easiest way to unpack is to open the
upper side of the box (check the labels), take out the separate units and carefully remove the cartons
and plastic bags. Take care to avoid putting pressure on the black loudspeaker’s stator plates.
If your packaging is not complete, do not operate the system but contact your dealer.
We recommend you to save all packaging materials for possible later use.
If any unit appears to be damaged when unpacking, do not operate the damaged unit. Repack the unit
in its original carton and notify your authorized Final Sound dealer immediately.
Assembling Model 600i/1000i
Assembling the Model600i/1000i floor standing panels is straightforward. You need:
Two foot plates
Four RVS spacers
8 spikes or feet
6 hexagon screws (for inside the RVS spacers)
2 Allen keys
Four screws and four small pins
To Next Page
Loading...
Need help?
General