Quick Start Guide
Setting the Date and Time
Press Menu, select Date/Time under Systems.
Insert the current date and time and press OK to save.
Enrolling Fingerprints
Press Menu, go to User Manage and select New User.
Key in a User ID, select Enroll FP and place the finger on the scanner 3
times, according to the instructions.
Press OK to save then press ESC. Press OK again, and then ESC again to
return to the main screen.
Enrolling Cards
Press Menu, go to User Manage and select New User.
Key in a User ID, select Enroll Card.
Wave the card until the Card ID is displayed on screen. Press OK to save
and Esc to return to the main screen.
1
2
3
4
The Quick Start Guide is intended to provide the user with simple instructions on how to
setup the terminal date/time and communication as well as to perform fingerprint and
card enrollment and verification. For more details on other topics of terminal management,
refer to the terminal’s hardware user manual available in the package or online at
• i-Kiosk 100 Plus: http://info.fingertec.com/ikiosk100p-4
• Q2i: http://info.fingertec.com/q2i-4
• R3: http://info.fingertec.com/r3-4
©
2014
Timetec Computing Sdn Bhd. All rights reserved.• 102014
Default set value:
IP address - 192.168.1.201
Subnet mask - 255.255.255.0
Gateway - 192.168.1.1
Dev ID - 1
Password - 0
Communication Settings
Press Menu > COMM > Network > Set value
for IP/Subnet mask/Gateway > OK (Save) >
Security > Device ID > Set 0 > OK (Save) >
ESC to return to main screen > Restart to
apply changes.
R3 Q2i i-Kiosk 100 Plus
L.E.D Display
LCD Screen
RFID Card
Induction Area
Speaker
Fingerprint
Sensor
Reset Button
USB Port
RESET
Keypad
M/OK
Button
Terminal Overview • R3
To Next Page
Need help?
General
