ENCLOSURE
INSTALLATION
DIAGRAM
1. Position the back plate properly on top
of the mounting plate; tighten the bolts
and nuts to join these two plates
together securely.
2. Position the wall plate that has been
attached to the back plate, and tighten
the screws to secure them on the
enclosure.
3. Mount the enclosure on a wall or a
surface and tighten the screws to secure
its position.
4. Hang the terminal on the back plate,
tighten the 2 screws at the bottom of the
terminal.
5. Make sure that the enclosure has been
mounted firmly by tightening all the
screws.
Note:
Installation of enclosure with access control
Note:
The package does not include the screws
needed to secure the enclosure to a wall
models
Before you start with step no. 1 above, make sure
that all the terminal's wires are put through the
enclosure, back plate and wall plate, and all the
wires are connected to the terminal's ports
correctly.
1
2
5
3
4
Terminal
Enclosure
1
1
2
3
5
5
3
3
3
4
Wall plate
Terminal
Enclosure
1
1
2
3
5
5
3
3
3
4
Wall plate
Back plate
3
w w w . f i n g e r t e c . c o mw w w . f i n g e r t e c . c o m
C
2011 FingerTec Worldwide Sdn. Bhd. All rights reserved.
INSTALLATION DIAGRAM • R2
INSTALLATION DIAGRAM • AC900
INSTALLATION DIAGRAM • Kadex
Enclosure
1
3
4
Wall plate
Back plate
Terminal
1
1
2
2
3
3
3
INSTALLATION DIAGRAM • i-Kiosk 100
Terminal
Enclosure
Wall plate
Back plate
4
1
1
1
3
3
3
3
2
2
Back plate
To Next Page
Need help?
General
