Mounting the Fire Cam BlackJack Holder!
With set screws loose, fit the BlackJack mount on the right or left brim of the
fire helmet. It can be installed above the brim or below the brim depending on
the view from your camera. Snug the 2 set screws on the brim BEING
CAREFUL NOT TO OVER TIGHTEN. Place the camera inside of the
BlackJack mount making sure the button is on the top and camera is level.
Tighten down the set screw to hold the camera BEING CAREFUL NOT TO
OVER TIGHTEN. If the set screw starts to make marks on the camera, this
will not damage the integrity of the unit. A small piece of black tape can help
limit the marks.
WARRANTY / DISCLAIMER:!
Abuse of Camera IS NOT covered under warranty. Fire Cam warrants its
products against defects in material or workmanship for 12 months from date
of purchase unless otherwise specified. This warranty also includes the "Fire
Cam Damage" warranty. If the cameras components get damaged in a fire,
you are covered for one free replacement. The Fire Cam 4K Fire Helmet
Camera’s warranty is limited to the replacement or repair of the defective item
at no charge if we determine the item to be defective. This warranty shall not
apply to any item subject to misuse including such as failure by buyer to
follow instructions, product modification, normal wear and tear, negligent or
improper operation. Abuse of camera, cable or accessories IS NOT covered
under the warranty. Fire Cam products are not recommended for concrete
training towers or flashover chambers where it could sustain high temps for
long periods of time. Electronic damage due to over-voltage, incorrect polarity
from product power supplies, or incorrect MAINS voltage is not covered under
the warranty. DO NOT USE ANY AFTERMARKET CHARGERS FOR YOUR
CAMERAS. Fire Cam chargers are designed specifically for Fire Cam’s only.
Modification, repair, or attempted repair by anyone other than Fire Cam or
without the written permission of Fire Cam will void this warranty. This
warranty covers the cost of factory repair, labor and parts on eligible
equipment which is returned. Equipment, which is repaired under this
warranty will be
returned freight prepaid. If it is determined that the Fire Cam does not need
repair, the purchaser shall pay for return shipping charges. Disclaimer: Fire
Cam does not assume any responsibility for any accidents or injuries incurred
to the user of the Fire Cam Fire Helmet Camera.
WARNING!!
Firefighting is a dangerous activity and should only be performed by a trained
professional. The end user of Fire Cam products assumes all responsibility
connected with the use of this product including but not limited to continuing
education, and activity that conforms to local Standard Operating Procedures.
Neither the manufacturer nor any distributor assumes any liability for injuries
To Next Page
Loading...