Take a Video
To take videos with the Fire Cam Onyx, make sure that the
Video/Photo switch ④ is set in the video mode. Then, choose 4K or
1080p resolution by switching the 4K/1080p switch ⑨. Refer to
Settings.TXT File to change FPS (frames per second) options for
4K/1080p. The recommended default setting is set at 4k@30fps/
1080p@60fps. Turn on the camera by pressing the Power button
②. Auto record is the default setting. Camera will start recording
after power on sequence. The red LED will blink while the video is
recording. Press the Power/Shutter button ② again, it will beep
twice and vibrate once to stop recording. Camera will be in standby
mode and recording can be started again by pressing power button.
! Take Still Pictures
To take still pictures with the Fire Cam Onyx, make sure that the
Video/Photo switch ④ is set to the left for photo mode. You may
choose 5MP/12MP by switching 4K/1080p switch ⑨ (4K=5MP /
1080P=12MP). Turn on the camera by pressing the Power button
②. Auto record is the default setting. Camera will start taking
pictures. The red LED will blink and it will beep once. Press the
Power/Shutter button ② again and it will beep twice to stop taking
photos and to go back to the standby mode.
In photo mode the Fire Cam Onyx will take sequentially photos
every 3 seconds. It stops automatically if the battery is empty or if
the micro SD card is full. Please note that the camera can be
stopped only when red LED is ON. When green LED is ON, it
indicates that the photo file is being saved onto the micro SD card
and recording can’t be stopped.
To Next Page
Loading...