5
ASSEMBLY
Attention: In order to prevent Bio-Ethanol from being inadvertently
spilled on parts of the product or in its vicinity, never place the burner into
the table replace when it is already lled.
1. Mount the glass onto the metal frame with the screws.
2. Put the burner into the metal frame.
3. Make sure the product is placed on a stable and level surface.
4. The surface must support a minimum of 10 kg. If it cannot support 10
kg, additional support is required.
Adding the Bio-Ethanol
1. Do not take out the ber.
2. Use a funnel to pour the Bio-Ethanol into the burner.
3. When adding the Bio-Ethanol, please do not exceed the
maximum sign in the burner.
Igniting the Bio-Ethanol
1. Ignite the burner, but be aware, deagration or darting ames may
occur. Do not light the re from above; it should be lighted from the
side. Keep a safe distance from the product.
2. The product can only be used in rooms of adequate size. The room size
should amount to at least 66 m
3
, which corresponds to oor space of 30
m
2
with a room height of 2,20 m.
3. Make sure that the product is not situated on heat-sensitive or
ammable bases and that no accumulation of heat can occur on
ceilings and walls. For this purpose, ensure the distance between the
product and the room ceiling is at least 1,8 meters.
4. Please keep minimum distance of 1 meter away from any burnable
material and objects.
Note: if the Bio-Ethanol in the burner could not be ignited after repeated
attempts, it is possible that a signicant portion of the alcohol has already
evaporated; thereby reducing the ignitability. In such case, please wait for a
few minutes and then dispose of the Bio-Ethanol, which is still in the burner.
Dispose of this Bio-Ethanol at a collection point for hazardous substances.
EN
1. 2.
To Next Page
Loading...
