FireplaceXtrordinair Elite Fireplacextrodin 36-Elite User Manual (English)

Questions and Answers:

A
Adrienne DeanJul 25, 2025
Why does smoke enter the room during FireplaceXtrordinair Indoor Fireplace start-up?
- B
  Brittany FarrellJul 26, 2025
  Smoke might enter the room during start-up of your FireplaceXtrordinair Indoor Fireplace due to a cold air blockage. Burning a piece of newspaper can help establish a draft. Another reason could be that the by-pass is closed. Open the by-pass by pulling the ring above the door all the way out. Also, ensure the air control is fully open to the left. If more air is needed, slightly crack the door.
G
Gina DodsonJul 31, 2025
What to do if smoke enters the room while reloading FireplaceXtrordinair Indoor Fireplace?
- M
  Michelle ChristensenJul 31, 2025
  If smoke enters the room while reloading your FireplaceXtrordinair Indoor Fireplace, it may be because the by-pass is closed. Open the by-pass (the ring above the doors) using gloves or a tool before opening the door. It could also be due to insufficient draft, which can be affected by chimney height and outside conditions. Adding more pipe or a draft-inducing cap may help.
D
David CastanedaAug 6, 2025
How to fix FireplaceXtrordinair Indoor Fireplace that does not burn hot enough?
- W
  William MathewsAug 6, 2025
  If your FireplaceXtrordinair Indoor Fireplace isn't burning hot enough, the wood may be wet. Also, insufficient draft, affected by chimney height and outside conditions, can cause a slow burn. Adding more pipe or a draft-inducing cap may help. Ensure the air control is fully to the left and slide it back and forth to ensure it's not stuck.
C
Carly MasseyAug 13, 2025
What to do if kindling does not start in FireplaceXtrordinair Indoor Fireplace?
- C
  Colton CastroAug 13, 2025
  If the kindling in your FireplaceXtrordinair Indoor Fireplace doesn't start and the fire smolders, it could be due to a cold air blockage; try burning a piece of newspaper to establish a draft. Also, you might not be using enough starter paper, so add more newspaper if needed. Make sure the by-pass is open by pulling the ring above the door all the way out. Additionally, ensure the air control is fully open to the left, and if more air is needed, slightly crack the door.
A
Andrew CastroAug 18, 2025
Why Blower Does Not Run in FireplaceXtrordinair Indoor Fireplace?
- C
  Christopher Gray Jr.Aug 19, 2025
  If the blower in your FireplaceXtrordinair Indoor Fireplace isn't running, it's normal if the fireplace hasn't reached temperature yet, usually taking 15 to 30 minutes. Otherwise, check the household breaker or fuse to ensure electricity is reaching the blower.

FireplaceXtrordinair Elite Fireplacextrodin 36-Elite Specifications

General

Brand	FireplaceXtrordinair
Model	Elite Fireplacextrodin 36-Elite
Category	Indoor Fireplace
Language	English

Summary

Safety Notice

Introduction

Important Information

Details on model, serial number, purchase date, and warranty card for service and coverage.

Safety Precautions

Installation and Local Requirements

Ensuring proper installation by a qualified installer and checking local building/fire official requirements.

Fuel and Flammable Storage

Use only cord wood and store flammables away from the fireplace to prevent fire hazards.

Safe Operation Practices

Guidelines for operating the fireplace safely, including door management, ash disposal, and clearances.

Supervision and Airflow

Supervise children and ensure proper airflow by not blocking vents for safe operation.

Further Safety Guidelines

Maintenance and Repair Safety

Follow instructions for maintenance, chimney inspection, and proper fuel usage. Keep the manual handy.

Warranty and Liability Disclaimer

Travis Industries, Inc. disclaims warranties for installation/maintenance and consequential damages.

Specifications

Features

Details on log length, firebox capacity, burn time, glass doors, firebrick, and blower.

Heating Specifications

Information on approximate heating capacity and maximum burning time.

Electrical Specifications

Details on the blower's electrical draw in amps and watts.

Packing List

Lists components shipped with the fireplace, faceplate, and door(s).

EPA Compliance

Confirms the heater meets EPA Phase II requirements for particulate emissions.

Operation - Initial Setup

Before Your First Fire

Essential steps before initial use: cleaning, installation verification, paint curing, and handling over-firing.

Curing the Paint

Explains the process of curing the heat-activated paint and initial fumes emitted.

Over-Firing the Fireplace

Warning and guidance on preventing over-firing, which can damage the unit and void the warranty.

Operating During a Power Outage

Advice on operating the fireplace safely during power outages to prevent overheating.

Acid Wash

Precautions regarding acid wash used for masonry and its potential effect on gold finishes.

Operation - Door Management

Opening the Door(s)

Step-by-step instructions for opening and closing single and double fireplace doors.

Closing the Door

Guidance on properly closing single and double fireplace doors to ensure a good seal.

Opening Hot Doors

Important warnings and procedures for safely opening hot fireplace doors to manage smoke and airflow.

Operation - Fire Controls and Starting

Location of Controls

Identifies the location of key controls like By-Pass, Air Control, and Blower Speed.

Starting a Fire

Detailed instructions and safety warnings for starting a fire, including draft establishment and fuel use.

Operation - Combustion and Burning Tips

Maintaining Catalytic Burn-Off

Explains the function of the catalytic combustor and how to operate it effectively.

Normal Operating Sounds

Describes expected sounds during normal operation, such as blower noise and firebox creaks.

Hints for Burning

Tips for efficient and effective burning, including wood selection, stacking, and ash management.

Selecting Wood

Dry Wood is Key

Emphasizes the importance of dry wood for efficient burning, low smoke, and reduced creosote.

Testing Wood Moisture

Methods for testing wood moisture content, including using a meter or sound.

Why Dry Wood is Key

Explains how wet wood negatively impacts fire temperature, creosote, and burn efficiency.

Wood Cutting and Storage

Guidance on cutting wood to length, quartering, and proper storage for drying.

Prohibited Fuels

Lists fuels that should not be burned to protect the combustor and prevent fire hazards.

Troubleshooting

Smoke Enters Room During Start-Up

Common causes and solutions for smoke entering the room when starting the fireplace.

Kindling Does Not Start / Fire Smolders

Troubleshooting tips for starting a fire, including issues with kindling and smoldering fires.

Smoke Enters Room While Re-Loading

Addresses smoke spillage into the room during the process of reloading the fireplace.

Fireplace Does Not Burn Hot Enough

Identifies reasons why the fireplace might not be burning hot enough and how to fix it.

Blower Does Not Run

Diagnosing and resolving issues where the blower is not operating.

Faceplate is Cold

Explains why the faceplate might be cold and that it is normal under certain airflow conditions.

Fireplace Does Not Burn Overnight

Troubleshooting steps if the fireplace fails to maintain an overnight burn.

Maintenance - Daily Tasks

Daily Maintenance

Routine checks and cleaning tasks for the fireplace while it is in use.

Check Ash, Remove if Necessary

Instructions on how to safely check and remove ash from the fireplace.

Clean Gold Surfaces

Guidance on cleaning gold surfaces using denatured alcohol and a soft cloth.

Maintenance - Component Checks

Twice Yearly Maintenance

Scheduled maintenance tasks to be performed twice a year.

Check Firebrick and Baffle

Instructions for inspecting the firebrick and baffle for damage or proper seating.

Clean the Combustor

Steps for cleaning the catalytic combustor to ensure efficient operation.

Clean the Blower Filter

Procedure for cleaning the removable filter in the convection blower assembly.

Maintenance - Door and Glass

Check Door Seal, Adjust if Necessary

How to check and adjust the door gasket and latch for a proper seal.

Glass Inspection & Removal

Instructions for inspecting, removing, and replacing the fireplace glass.

Maintenance - Chimney and Parts

Check Chimney for Creosote Build-Up

Procedure for inspecting the chimney for creosote and the risks associated with it.

Replacement Parts List

A comprehensive list of available replacement parts with their part numbers.

Safety Label

Limited 7 Year Warranty

Years 1 & 2 Coverage: Parts & Labor

Details on parts and labor covered for the first two years of the warranty.

Years 3-5 Coverage: Parts & Labor

Details on parts and labor covered from year three to five.

Years 6 & 7 Coverage: Parts Only

Details on parts covered only from year six to seven.

Conditions & Exclusions

Important conditions and exclusions that apply to the 7-year warranty.

If Warranty Service Is Needed

Procedure for reporting and obtaining warranty service for the appliance.

Optional Equipment

Temperature Meter

Information on the optional temperature meter for monitoring combustor light-off.

Related product manuals

FireplaceXtrordinair 36 DV XL

52 pages

ProBuilder 36 CleanFace MV

28 pages

FireplaceXtrordinair 44-Elite

24 pages

FireplaceXtrordinair 36DV-A/R

40 pages

FireplaceXtrordinair Elite Fireplacextrodin 36-Elite User Manual

Table of Contents