GUARANTEE
The manufacturer warrants to the original consumer purchaser each
new smoke alarm to be free from defects in material and workman-
ship under normal use and service for a period of six (6) years in the
United Kingdom and Republic of Ireland from date of
purchase. We agree to repair or replace, at its option, any defec-
tive smoke alarm, provided that it is returned with postage prepaid
and with proof of purchase date to the manufacturer. This warranty
does not cover damage resulting from accident, misuse or abuse or
lack of reasonable care of the product. This warranty is in lieu of all
other express warranties, obligations or liabilities. THE IMPLIED
WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A
PARTICULAR PURPOSE ARE LIMITED TO A PERIOD OF SIX (6)
YEARS FROM PURCHASE DATE. IN NO CASE SHALL THE
MANUFACTURER BE LIABLE FOR ANY INCIDENTAL OR
CONSEQUENTIAL DAMAGES FOR BREACH OF THIS OR ANY
OTHER WARRANTY, EXPRESS OR IMPLIED, WHATSOEVER, EVEN
IF THE LOSS OR DAMAGE IS CAUSED BY ITS NEGLIGENCE OR
FAULT.
Return units freight prepaid to your local reseller. For information on
your local reseller in the U.K. and Republic of Ireland, contact:
FIREX PRODUCTS
KIDDE SAFETY EUROPE LIMITED
Mathisen Way
Colnbrook, Berkshire SL3 0HB
United Kingdom
Tel.: +44 (0) 1753 685148
www.smoke-alarms.co.uk
8
Leading authorities recommend that both Ionisation and photoelec-
tric smoke alarms be installed to insure maximum detection of the
various types of fires that can occur within the home. Ionisation
sensing alarms may detect invisible fire particles (associated with
fast flaming fires) sooner than photoelectric alarms. Photoelectric
sensing alarms may detect visible fire particles (associated with
slow smouldering fires) sooner than Ionisation alarms.
1374-7205-00
SOLUTION
1. Check that AC power is
turned on. Green LED
should be illuminated.
2. Turn off power. Remove
smoke alarm from mount-
ing plate and:
a. check that connector plug
is securely attached.
b. check that battery is
properly attached to con-
nector.
3. Clean smoke alarm.
1. Turn off power and replace
battery. See in the MAINTE-
NANCE AND CLEANING
section.
2. Clean smoke alarm.
3. Verify that unit has been
under mains operation for a
minimum of 2 full days. If
the beeping persists after
required charging period,
return the unit for service.
1. Hire an electrician to move
smoke alarm to a new
location. See "SMOKE
ALARM PLACEMENT".
1. Press and hold test button
for at least three seconds
after the first unit sounds.
2. Hire an electrician to
ensure smoke alarms are
properly connected.
Ten (10) year end of life warn-
ing. Alarm must be replaced
(REPLACE IMMEDIATELY! )
To Previous Page
Loading...
Need help?
General
