EasyManuals Logo

Firman SPS 2000i User Manual

Firman SPS 2000i
72 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #12 background imageLoading...
Page #12 background image
CHECKING COMPONENTS
Do not refuel while smoking or near open flame or other such potential fire hazards.
Otherwise a fire accident could occur.
Make sure you review each warning in order to prevent fire hazard.
Fuel leakage from fuel hose etc. ,
Tighten any loose bolts or nuts.
Check components for damage or breakage.
Check following items before starting engine:
Do not refill tank while engine is running or hot.
Close fuel valve before refueling with fuel.
Be careful not to admit dust, dirt, water or other foreign objects into fuel
Wipe off spilt fuel thoroughly before starting engine.
Keep away from open flames.
CHECK ENGINE FUEL
WARNING
Page 11
WARNING
Fuel must meet these requirements:
Clean, fresh, unleaded gasoline.
Octane rating of 86(R+M)/2 or higher.
Research Octane Number(RON)91
octane minimum.
Gasoline up to 10% ethyl alcohol,90%
unleaded is acceptable.
Methyl Tertiary Butyl Ether(MTBE) and
unleaded gasoline blend(max 15%
MTBE by volume)are approved.
Do not add oil to gasoline.
Do not overfill fuel tank.
Do not use gasoline older than 30 days.
NOTE:
E15,E20 and E85 art NOT approved and should NOT be used, effects of old, stale
or contaminated fuel are not warrantable.
1. Clean the area around the fuel cap.
2. Remove the fuel cap.
3.Slowly add fuel to the tank. DO NOT OVER FILL.
4.Screw on the fuel cap and wipe away any spilled fuel.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Firman SPS 2000i and is the answer not in the manual?

Firman SPS 2000i Specifications

General IconGeneral
BrandFirman
ModelSPS 2000i
CategoryPortable Generator
LanguageEnglish

Related product manuals