Firman T09371 - Page 22

OPERATION
e Exchanging fuel cylinders to allow the first cylinder to warm up, repeating as necessary.
• Placing the LPG cylinder at the end of the generator near the hand le, where engine fan
• air flows out from the generator. This air is slightly heated by air flowing over the engine.
Do not place the LPG cylinder in the path of the muffler exhaust outlet.
e The LPG cylinder and components can be temporarily warmed by pouring warm water over
them .
5. Starting the Generator on NG
1. Before starting the generator, check for loose or missing parts and for any damage which may
have occurred during shipment. Ensure spark plug, muffler, fuel cap, and air cleaner are all in place.
2. Operate portable generator only outdoors and downwind at least 20 ft. (6 m) from occupied
spaces with exhaust pointed away to reduce the risk of carbon monoxide accumulating.
3. Connect the NG hose to both the NG source and po r table generator LPG/NG Hose Connector (inlet).
NG
4. Fully open t he NG source valve.
En g li sh 21
Custo mer Serv ice 1- 844 -FIRMAN1