Firman T09371 - 6. Connecting Electrical Loads

OPERATION
10.For recoil start only- Move the choke lever to the "RUN" position.
11. For recoil start only - PU LL-TO-RUN Pu II the starter cord slowly u nti I resistance if felt and pu II
rapidly to run the portable generator.
If the engine fai Is to start in 1-2 pul Is with choke in the RUN position, move choke lever to START
position and repeat the PULL-TO-PRIME step (9).
12.
For electric start only- Flip the engine switch to the START (II) position for a few seconds and
then release.
13. For electric start only- Move the choke lever to the RUN position.
14. Allow portable generator to run at no load for a few minutes to stabilize before plugging in
any electrical devices.
NOTICE If engine starts but fails to run, orif portable generator shuts down during operation,
check oil level. See Low Oil Shutdown section for more information.
English 23
Customer Service 1-844 -FIRMAN1