– 36 –
USER FUNCTIONS
USER FUNCTIONSUSER FUNCTIONS
USER FUNCTIONS
Scheduling User Interface
xxdn
Device # 1-16
Device Number
Enter a two-digit device number (xx = device number)
Selections
01-16
[*] = Accept entry and continue
[#] = Return to previous prompt
Table 1 - Event Identifier Entries
Event Description
0 = Empty No event scheduled (or schedule is temporarily disabled)
1 = X10 Device
Turn an X10 device, either on or off at begin/end times. This is a time
driven event that requires a begin and end time.
NOTE: SH10A siren cannot be used.
2 = Latch Key Report
(reports only to pager)
A special pager report (7110000) indicating system not yet disarmed will
be sent (will have a start/end time to send the report). This is a window
driven event that requires a begin/end time.
NOTE: This option requires that certain features be programmed by your installer.
Check with your installer if you plan to schedule this event.
3 = Automatic Stay Arming
System will bypass any open zones and arm automatically, at a
programmed time. A report will be sent to the central station, indicating
system has been auto armed stay, along with all bypass reports. This is a
time driven event that requires a begin time to send a report.
NOTE: Prior executing auto stay arming or scheduled stay arming, force bypass
will be executed - if Forced Bypass was enabled.
4 = Reminder
Announcements
System will announce the message recorded by your installer. This will be
repeated every minute until a key is depressed, or a button type zone
does an arm or disarm. This is a reminder announcement that requires a
begin day to send a report.
NOTE: Make sure installer programmed the message at the time of installation.
5 = Alarm Clock System will sound a trouble tone (beep) on the speaker, which will
continue until a key is depressed. This is a an alarm clock that requires a
begin day to send a report.
To Next Page
Loading...
Need help?
General
