E-1
COMPLIANCE WITH FCC REGULATIONS
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
NOTE : This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
CAUTION: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
PRODUCT FEATURES
• Passive Infrared (PIR) Sensor & Receiver
• Wireless RF Transmission Up to 300 feet
• Sensor Detects Motion and Triggers the Receiver to Turn on an alarm or Chime
Sensor Detection Range up to 30 Feet (mounted at 5’ height)
Sensor Detection Angle up to 30 Degree
• Sound Volume Hi/Low Switch
• Alarm/Off/Chime Function Selector
• Sensor - 9V Battery Operation (battery not included)
• Receiver 3 x “C” Size Batteries (not included) or compatible with DC Adaptor (not
included)
• Battery Low Indicator LED for Sensor and Receiver
• Trigger LED on Sensor
• Wireless, Easy Installation
• Water Resistant Sensor
To Next Page
Loading...
Need help?
General
