Step 6 - Re-assemble and install
6.1 - Mount channel assembly to door with channel
underneath new hinge stile bracket. Attach device to
lock stile and tighten screws, then tighten hinge stile
bracket mounting screws.
6.2 - Make wiring power connections and test for
proper Motor operation. Power Supply MUST be class
II rated in order to meet UL listing requirements.
6.3 - Re-assemble pushbar onto channel and
activating assemblies by sliding onto pins of
activating brackets – pins will only fit in lower
pushbar slots.
6.4 - Make sure the pushbar bracket stop tabs are
installed with tabs turned up, away from the channel.
6.5 - Reinstall end caps.
To Previous Page
Loading...