page 97
DTC 200
CHOOSING WORKING REGIME
Choosing working regime
Before first of use, the working regime must be selected. It is set
by jumpers in the electronic circuit. -
For each application is specific jumper position.
In further by every example is stated jumper’s position.
Possible jumper’s settings:
for example:
2. On-wall connection
a) Lead cables into the thermostat housing like as shown on the
picture. On one side lead the sensor cables and on the other the
rest. With two discharger screw the cables very tight to
prevent the extraction.
a)
b)
c)
ELECTRICAL CONNECTION:
Non-isolated part of the conductor must be in the terminal
housing!
Before each interventions in the thermostat first dis-
connect the main power!
d)
b) If it’s not enough space for cables, use the knife and widen
the lead.
c) Cut the holes for cables lead on the housing cover
d) Use the knife and cut on spots 1 and 2 and brake remain.
ELECTRICAL CABLES CONNECTION
1. Flush mounted connection
Cables in the wall case lead through the holes at the bottom
of thermostat.
To Next Page
Loading...
