8
2.5 seconds no Option programming menu 2 - Installers Only.
Half second no Activates passive arming (vehicle will arm/lock 30 seconds after the vehicle is disarmed)
Half second yes
Activates timer start mode. Timer start mode has multiple programmable settings:
duration settings, temperature settings and self start settings.
Half second yes
Activates the built in Turbo Timer function. Additional installation is required when using
this feature on automatic transmission vehicle’s.
2.5 seconds no Car Check / Secure Auxiliary
If you would like additional information on the functionality of your 1 Way companion remote, please visit
the support page at www.compustar.com to download the full user manual.
General System Functions
The remote transmitter functions are predetermined and programmed from the factory. The five button
configuration allows for many functions to be performed through a series of tapping and/or holding
buttons.
Sending Commands
When in range and a command has been sent the remote will beep and unique LED will flash blue or red.
For example, to send a remote start command from the pager, hold the Key/Start
button for 2.5
seconds. The remote will beep confirming the command has been sent and that the remote is in range.
Once the vehicle has successfully remote started, the remote will receive a three beep and LED
command indicating the vehicle is running.
Receiving Commands
The remote pager will receive commands indicating the status of the vehicle, confirmation of sending
commands and remote start notifications. For example, after sending the lock command, the pager will
receive LED and chirp signals confirming that the vehicle has been successfully locked/armed. To see if
your pager is in range, tap the
button for a half second – if the remote receives an audible and LED
confirmation then it is in range.
Active Lock/Arm and Unlock/Disarm
Tap the Lock button for a half second to lock/arm your vehicle. Tap the Unlock button
to unlock/disarm your vehicle. If equipped this will also activate your starter kill and anti grind
feature. Also you will not be able to start your vehicle with the key until unlock/disarm.
IMPORTANT: If the alarm has been triggered (Siren is sounding, parking lights flashing, and horn
honking), you must wait until the remote pager has been paged before disarming the alarm – the first
button tap will shut off the alarm and the second will unlock/disarm the system.
Passive Lock/Arm
The system can be configured to passively lock and arm the vehicle. Put the system in
passive by tapping the Trunk + Key Start buttons
button for a half second.
The remote will beep once and the LEDs will illuminate to indicate the system is in passive lock and
To Next Page
Loading...
Need help?
General
