foam attachment
12. Run the 6mm (1/4”) tubing to the back of the
refrigerator ensuring there is enough tubing to pull
the refrigerator out for service.
13. Using the measurement guide shown in Diagram
6, mark out 16mm, on the end of the tubing as
shown in Diagram 7.
14. Insert the tubing marked 16mm into the water
(solenoid) valve up to the marked line as shown in
Diagram 8.
15. Pull gently on tubing to ensure it is locked in as
shown in Diagram 9.
16. The completed installation should look like
Diagram 6.
17. Turn the isolating faucet on and check that all
connections are dry and free of drips.
18. Coil water line tubing behind the refrigerator. Push
your refrigerator into place being careful not to kink
or squash the water line tube running into the
water (solenoid) valve.
19. Read pages 17 – 18 carefully and then turn
refrigerator on.
https://producthelp.fisherpaykel.com/au/Cool/Fridges/Bottom_Freezer/Without_Ice_and_Water/790mm/RF522BRPX6/User_G…
Updated: Mon, 27 Apr 2020 00:46:14 GMT
Powered by
10
To Next Page
Loading...
