connect to potable water supply only.
• DO NOT install on line pressure above 119psi (827kPa) or below 22psi (150kPa).
• DO NOT use on hot water supply 38°C max.
• DO NOT cut any length of tube shorter than 200mm.
• DO NOT install near electrical wires or water pipes that will be in the path of drilling when selecting the location
of filter system.
• DO NOT mount filter in such a position so that it will be struck by other items, such as wastebaskets, etc.
• DO NOT install the filter or any water tubing in direct sunlight as prolonged exposure to light can weaken plastic
components.
• DO NOT install in a location that is susceptible to freezing temperatures as damage to the housing could occur.
• DO NOT screw filter to the refrigerator.
• DO NOT install the filter or any water tubing in high temperature areas eg in a ceiling cavity.
• AVOID contamination of pipes during installation.
• DO NOT use copper tubing. The plastic tubing supplied should always be used.
• DO NOT continuously dispense water for longer than 2 minutes.
Installation instructions:
1. Ensure the refrigerator is NOT plugged into a power supply.
2. Locate a cold water supply/feed only suitable for a water
connection. Tee and tap fitting is not supplied.
3. Connect the 200mm (8”) tubing to the outlet of the PRV (blue collet)
and the inlet connection of the water filter cartridge as shown in
Diagram 1. Gently pull on both ends to ensure it is locked.
Diagram 1 PRV
connection
https://producthelp.fisherpaykel.com/au/Cool/Fridges/Bottom_Freezer/Without_Ice_and_Water/790mm/RF522BRPX6/User_G…
Updated: Mon, 27 Apr 2020 00:46:14 GMT
Powered by
7
To Next Page
Loading...
