34
Drip tray
(Water dispensing models only)
The drip tray is designed to fit into the
bottom of the water dispenser panel.
To insert the tray ensure the
rounded sides are fitted into the
dispenser panel first.
The purpose of the tray is to
capture drips of water that may fall
after dispensing.
The tray can be removed for cleaning.
ACTIVESMART™ OPERATING INSTRUCTIONS
Drip tray
Glass shelves – Freezer
Some models have glass shelving under the freezer bins. These can be
removed if required.
To remove
1
Remove the bin above the glass shelf (refer to ‘Fixed bins’)
2
Push on the clips below the bin runners on both sides of the shelf (A)
3
Lift the shelf up to remove from the supports
A
To Next Page
Loading...
Need help?
General
